Sensor, Wheel Speed, Front: Installation: All-Wheel-Drive

Courtesy of CHRYSLER GROUP, LLC

1. Install wheel speed sensor (2) head into knuckle (4) and install mounting screw (1). Tighten screw to 11 N.m (97 in. lbs.).
2. Attach wheel speed sensor cable and a NEW  routing clip (3) to knuckle (4).
3. Attach the sensor cable into the routing clip at the brake hose bracket.

   Courtesy of CHRYSLER GROUP, LLC

4. Connect sensor connector (2) to the body. When installing connector, make sure retaining clip on body connector is properly in place and sensor connect cannot be pulled out.
5. Install inner wheel liner. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
6. Remove the support and lower the vehicle.
7. Perform Verification Test and clear any faults. Refer to STANDARD PROCEDURE .