LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis (Single Page) >> Brakes >> Brakes Control Systems >> Antilock Brake System (Abs) (Service Information) >> Hydraulic/Mechanical >> Integrated Control Unit (ICU) >> Removal

Integrated Control Unit (ICU): Removal

NOTE:

Before proceeding, refer to CAUTION and WARNING .

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
    GC0170182Courtesy of CHRYSLER GROUP, LLC
  3. Remove primary and secondary brake tubes (2) at hydraulic control unit.
  4. Remove remaining four brake tubes (1) at hydraulic control unit.
  5. Disconnect Antilock Brake Module (ABM) wiring harness connector (3).
    GC0170098Courtesy of CHRYSLER GROUP, LLC
  6. Pull up on unit (4) and remove from mounting grommets in body side rail (2).
scientia non olet · About LEMON Manuals