LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Chime/Buzzer/Driver Assist (Service Information) >> Sensor, Blind Spot >> Removal

Sensor, Blind Spot: Removal

GC0158214Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
  2. Remove the rear bumper fascia from the vehicle. Refer to FASCIA, REAR, REMOVAL .
  3. Disconnect the rear body wire harness connector (4) from the Left Blind Spot Sensor (LBSS) or Right Blind Spot Sensor (RBSS) (3) connector receptacle.
  4. Disengage the latch tabs (2) of the rear bumper fascia mounting bracket (1) and pull the LBSS or RBSS out of the bracket.
scientia non olet · About LEMON Manuals