Door, Rear: Installation
NOTE:
Have an assistant to aid in removal/installation.
- Support the front door with a suitable lifting device.
- Position and align the door hinge studs with the upper and lower hinge brackets using the reference marks made in removal.
- Push the door in towards the vehicle to seat the studs into the hinge brackets.
- Install and tighten the nuts into both the upper and lower front door hinge studs to secure the door hinge brackets to the door. Tighten the nuts to the proper torque specifications using the sequence shown in illustration. Refer to TORQUE SPECIFICATIONS .
- Remove the lifting device supporting the door.
- Carefully pull the body wire harness connector(s) out from the A-pillar far enough to reconnect them to the door wire harness boot and connector (1).
- Engage the front door wire harness boot and connector into the wiring clearance hole on the outside of the lower A-pillar.
- Reconnect the battery negative cable.NOTE:
For vehicles equipped with the optional Automatic Express Up power window feature, recalibration of this feature is required whenever power to the door module is disrupted.
- Adjust the door hinge positions as necessary to achieve proper door spacing and operation. Refer to GAP AND FLUSH, SPECIFICATIONS .