Base Brake Bleeding - SRT8: Notes
Use the following procedure to bleed the rear brake calipers of this vehicle. The front brake calipers may be bled using the same procedure as the standard model.
Before removing the master cylinder cover, wipe it clean to prevent dirt and other foreign matter from dropping into the master cylinder.
Use only Mopar® brake fluid or an equivalent from a fresh, tightly sealed container. Brake fluid must conform to DOT 3 specifications.
For bleeding the antilock-brake hydraulic system, Refer to STANDARD PROCEDURE - ANTILOCK BRAKE SYSTEM BLEEDING .
Do not pump the brake pedal at any time with a bleeder screw open during the bleeding process. This only increases the amount of air in the system and makes additional bleeding necessary.
Do not allow the master cylinder reservoir to run out of brake fluid while bleeding the system. An empty reservoir allows additional air into the brake system. Check the fluid level frequently and add fluid as needed.
Pressure bleeding is highly recommended to bleed this brake system to make sure all air is removed from system. Manual bleeding may also be used, but additional time is needed to remove all air from system.
Although the pressure method is recommended for bleeding the base brake system, the manual method can also be performed. Both methods are presented in this text.