Pedal(S), Brake And/Or Accelerator: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Install the brake pedal assembly under instrument panel and slide over booster push rod.
2. From engine compartment side, push power brake booster mounting studs back through dash panel and brake pedal bracket.
3. Install two upper mounting nuts fastening pedal bracket to upper dash panel. Do not tighten at this time. 
4. Install the four Brake Pedal/Booster Nuts (4), and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
5. Tighten two upper Brake Pedal/Booster Nuts (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
6. Slide booster push rod onto brake pedal pin. Install NEW  retaining clip (3) securing push rod to brake pedal.
7. Connect the stop lamp switch wiring harness connector (3).
8. Install steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
9. Install driver side silencer under instrument panel.
10. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
11. Road test vehicle testing operation of brakes.