Front-Non SRT
Installation process is the same for both sides of the vehicle.
Inspect brake pads before installation
Refer to PADS, BRAKE, INSPECTION .
- Clean hub face to remove any dirt or corrosion where rotor mounts.
- Install brake rotor (2) onto the hub
- Install the brake caliper (6) and adapter (3) over the brake rotor as an assembly.
- Install NEW brake caliper adaptor to knuckle bolts (1), and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the tire and wheel assembly. Refer to INSTALLATION .
- Remove support and lower the vehicle.
- Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
- Check and adjust brake fluid level in reservoir as necessary.CAUTION:
If NEW brake rotors or pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during the first brake applications following installation.
CAUTION:A burnish procedure must be performed anytime NEW brake pads or rotors are installed on a vehicle equipped with the Police Package. This procedure is particularly important in situations where high speed pursuit is a possibility. It is recommended that the procedure be performed by the Police agency operating the vehicle so it can be performed in a safe controlled environment. This information is covered in the Police Package Owners Manual Supplement which was supplied when the vehicle was originally delivered.
- Road test the vehicle and make several stops to seat the brake pads to the rotor.
