Stud, Wheel, Rear: Installation
- Install replacement wheel stud into flange of hub and bearing from rear (2). Install a stack of washers (3) (approximately 5, depending on thickness) over stud, then install a standard wheel mounting (lug) nut (1) on stud with flat side of nut against washers.
- Tighten wheel mounting nut (1), pulling wheel stud into flange of hub and bearing. Once head of stud (2) is fully seated against rear of hub flange, remove nut and washers from wheel stud.
- Install parking brake shoe adjuster (1) between upper and lower parking brake shoes. Position end of adjuster with star wheel upward. Once in place, slide upper shoe downward against adjuster mounting slot, taking up any slack between two pieces.
- Using appropriate tools, install spring (3) at adjuster.
- Install brake rotor. Refer to ROTOR, BRAKE, INSTALLATION .
- Install the tire and wheel assembly. Refer to INSTALLATION .
- Adjust parking brake shoes. Refer to SHOES, PARKING BRAKE, ADJUSTMENTS .
- Remove support and lower the vehicle.
