LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System (Abs) (Service Information) >> Electrical >> Sensor, Wheel Speed, Rear >> Removal

Sensor, Wheel Speed, Rear: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0170292Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    The left Wheel Speed Sensor (WSS) connector is gray in color, the right WSS is black in color as shown in the illustration.

  3. Disconnect the appropriate WSS wire harness connector (1).
    GC0170089Courtesy of CHRYSLER GROUP, LLC
  4. If removing left WSS, remove sensor cable retaining clips (1) along rear of crossmember near the rear differential.
    GC0170534Courtesy of CHRYSLER GROUP, LLC
  5. Remove WSS cable from routing clips (2) along toe link.
  6. Disconnect WSS cable at rear brake rotor shield.
  7. Remove the WSS head to knuckle bolt (1).
  8. Remove WSS.
scientia non olet · About LEMON Manuals