3.6L Single Muffler
NOTE:
When replacement is required on any component of the exhaust system, it is most important that original equipment parts (or their equivalent) be used.
- Install the exhaust pipe assembly into the catalytic converters, leaving the clamps (1) loose at this point.
- The tailpipe should be centered in the rear fascia opening.
- Install the left rear isolator mounting bolts (1, 2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- The tailpipe should be centered in the rear fascia opening.
- Install the right rear isolator mounting bolts (1, 2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the rear isolator mounting bolt (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Install the front isolator mounting bolt (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Check for proper alignment and clearance before tightening clamps.
- Tighten the band clamps (1) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Remove support and lower the vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
