3.6L/5.7L Dual Muffler
NOTE:
When replacement is required on any component of the exhaust system, it is most important that original equipment parts (or their equivalent) be used.
- Apply penetrating oil to band clamps.
- Install the exhaust pipe assembly (1) into the catalytic converters, leaving the clamps (2) loose at this point.
- Install the two rear isolator mounting bolts (1).
- Install the front isolator mounting bolt (1).
- Install left side resonator and tailpipe assembly flange nuts (3).
- Check for proper alignment and clearance to underbody and engine compartment components before tightening clamps.
- Check the clearance between muffler and resonator assembly and fuel tank. Clearance is 14mm (.55 in.) for V8 engine.
- Check the clearance at rear tunnel reinforcement. Clearance is 15 - 20mm (.59 -.78 in.).
- The tailpipe should be centered in the rear fascia opening.
- Tighten the band clamps to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Lower the vehicle.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
