Shock Absorber, Suspension, Coil-Over: Installation: SRT
NOTE:
Installation process is the same for both sides of the vehicle.
- Place shock assembly into front suspension using reverse direction in which it was removed.
- Install the upper ball joint into the knuckle. Refer to ARM, UPPER CONTROL, INSTALLATION .
- Install the strut to lower control arm bolt (4). Do not tighten bolt at this time.
- Install the stabilizer link (2) into shock assembly from front. Install the stabilizer link to strut nut (1). Tighten by holding the stabilizer link stud while turning nut, tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the Active Damping System (ADS) shock wiring harness connector (1).
- Install the splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
- Install the tire and wheel assembly. Refer to INSTALLATION .
- Remove the support and lower the vehicle.
- Install the three strut mount to body nuts (2), and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- If equipped, align shock tower cap with shock mounting nuts and snap into place.
- If right front strut was removed, install the supercharger coolant recovery container. Refer to RESERVOIR, COOLANT, INSTALLATION
.
- Tighten the strut to lower control arm bolt (4) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
