Rear Toe
NOTE:
Perform the following procedure to each side of the vehicle as necessary.
- Loosen the cam bolt and nut (1) securing the toe link to the rear crossmember (front of rear crossmember) just enough to rotate the cam bolt.NOTE:
When adjusting rear toe, the eccentric lobes on the toe adjustment cam bolts and washers are not to be facing downward. The lobes should only be facing upward or up to 90° to one side or the other from the 12 O'clock position.
- Rotate the cam bolt head (3) on the opposite side (rear) of the crossmember in either direction until the preferred alignment specification is obtained. Refer to WHEEL ALIGNMENT, TECHNICAL SPECIFICATIONS .
- While holding the cam bolt (3) from turning, tighten the toe link to crossmember nut to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Adjust rear toe on opposite side of vehicle using above procedure as necessary.
- Once rear toe is set, proceed to FRONT TOE below to set the vehicle's front toe.
