Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read the Body Control Module (BCM) DTCs and record on the repair order.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE DRIVER DOOR LOCK/UNLOCK MOTOR
1. Turn the ignition off.
2. Disconnect Driver Door Latch harness connector.
3. Turn the ignition on.
4. With the scan tool, read the BCM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 3
  No
  - Replace the Driver Door Latch in accordance with the Service Information. Refer to LATCH, DOOR, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE PASSENGER DOOR LOCK/UNLOCK MOTOR
1. Turn the ignition off.
2. Disconnect Passenger Door Latch harness connector.
3. Turn the ignition on.
4. With the scan tool, read the BCM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 4
  No
  - Replace the Passenger Door Latch in accordance with the Service Information. Refer to LATCH, DOOR, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (P910) DRIVER DOOR UNLOCK RELAY CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
NOTE:
Make sure the Door Lock/Unlock Switch is not activated while performing this step.
1. Measure the voltage between ground and the (P910) Driver Door Unlock Control circuit at the Driver Door Latch harness connector.
  Is there any voltage present?
  
  Yes
  - Repair the short to voltage on the (P910) Driver Door Unlock Relay Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 5
CHECK THE (P292) PASSENGER DOOR UNLOCK RELAY CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
NOTE:
Make sure the Door Lock/Unlock Switch is not activated while performing this step.
1. Measure the voltage between ground and the (P292) Passenger Door Unlock Control circuit at the Passenger Door Latch harness connector.
  Is there any voltage present?
  
  Yes
  - Repair the short to voltage on the (P292) Passenger Door Unlock Relay Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .