Diagnostic Test
- CHECK FOR AN ACTIVE DTC
- With the scan tool, read Body Control Module (BCM) DTCs and record on the repair order.
Is the DTC active?
Yes
- Go To 2
No
- The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- With the scan tool, read Body Control Module (BCM) DTCs and record on the repair order.
- CHECK THE REAR SUN SHADE SWITCH
- Turn the ignition off.
- Disconnect the Rear Sun Shade Switch harness connector.
- Turn the ignition on.
- With the scan tool, read BCM DTCs.
Is the DTC active?
No
- Go To 3
Yes
- Replace the Rear Sun Shade Switch in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK THE (Q558) REAR SUN SHADE SWITCH SIGNAL CIRCUIT FOR A SHORT TO GROUND
- Turn the ignition off.
- Disconnect the BCM C5/E harness connector.
- Check for continuity between ground and the (Q558) Rear Sun Shade Switch Signal circuit at the Rear Sun Shade Switch harness connector.
Is there continuity between ground and the (Q558) Rear Sun Shade Switch Signal circuit?
Yes
- Repair the short to ground in the (Q558) Rear Sun Shade Switch Signal circuit.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .