Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on and open one of the front doors.
  NOTE:
  A front door must remain open whenever checking or erasing Radio DTCs.
2. With the scan tool, record and erase the Radio DTCs.
3. Cycle the ignition switch from on to off, wait five seconds and then back to on.
4. Turn the Radio on and set the volume to 25.
5. Adjust the speakers to the Rear and center.
6. With the scan tool, read Radio DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE OPERATION OF THE RIGHT REAR AUDIO
1. Turn the ignition off.
2. Disconnect the Amplifier C1 harness connector.
3. Connect a jumper wire between the (X52) Right Rear Audio (+) circuit and the (X58) Right Rear Audio (-) circuits at the Amplifier C1 harness connector.
4. Turn the ignition on.
5. Adjust the speakers to the rear and center.
6. With the scan tool, read Radio DTCs.
  Is the DTC active?
  
  Yes
  - Go To 3
  No
  - Replace the Amplifier in accordance with the Service Information. Refer to AMPLIFIER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (X52) RIGHT REAR AUDIO (+) CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Disconnect the Radio C1 harness connector.
3. Measure the resistance of the (X52) Right Rear Audio (+) circuit between the Radio C1 harness connector and the Amplifier C1 harness connector.
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Go To 4
  No
  - Repair the (X52) Right Rear Audio (+) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (X58) RIGHT REAR AUDIO (-) CIRCUIT FOR AN OPEN
1. Measure the resistance of the (X58) Right Rear Audio (-) circuit between the Radio C1 harness connector and the Amplifier C1 harness connector.
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Replace the Radio in accordance to the service information. Refer to RADIO, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Repair the (X58) Right Rear Audio (-) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .