LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Controls >> Actuator, Blend Door >> Installation >> Right Side

Right Side

GC0096054Courtesy of CHRYSLER GROUP, LLC
  1. Position the blend door actuator (1) to the blend door cam (4).
  2. Install the blend door actuator onto the right side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the splines on the actuator output shaft (3) with those on the blend door cam (4).
    GC0170290Courtesy of CHRYSLER GROUP, LLC
  3. Install the screws (1) that secure the blend door actuator (3) to the air distribution housing (4) and securely tighten the screws.
  4. Connect the HVAC wire harness connector (2) to the blend door actuator.
  5. Install the glove box trim panel and glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
    GC0170245Courtesy of CHRYSLER GROUP, LLC
  6. Install the push fasteners, connect the wire harness connector and install the instrument panel closeout (3).
  7. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  8. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals