LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Controls >> Transducer, A/C Pressure >> Installation

Transducer, A/C Pressure: Installation

GC0158231Courtesy of CHRYSLER GROUP, LLC
NOTE:

Use only the specified O-ring as it is made of special material for this system. Use only refrigerant oil of the type required for the A/C compressor.

  1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it onto the liquid line fitting.
  2. Install the A/C pressure transducer (2) onto the Internal Heat Exchanger (1) and securely tighten the A/C pressure transducer (2).
  3. Connect the wire harness connector (3) to the A/C pressure transducer (2).
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals