LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Plumbing >> Line, A/C Suction >> Removal >> Suction Line

Suction Line

GC0158240Courtesy of CHRYSLER GROUP, LLC
NOTE:

3.6L compressor and refrigerant lines shown in the illustration.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the air cleaner housing. Refer to BODY, AIR CLEANER, REMOVAL .
  4. Remove the nut (1) that secures the suction line (2) to the A/C compressor.
  5. Disconnect the A/C suction line from the A/C compressor and remove and discard the dual plane seal.
  6. Install plugs in, or tape over the opened suction line fitting and compressor inlet port.
    GC0158228Courtesy of CHRYSLER GROUP, LLC
  7. Remove the nut (3) that secures the suction line to the Internal Heat Exchanger (IHX) (1).
  8. Disconnect the suction line from the IHX and remove and discard the dual plane seal.
  9. Install plugs in, or tape over the opened line fittings.
  10. Remove the suction line from the engine compartment.
scientia non olet · About LEMON Manuals