LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (3.6L Engine (Service Information)) >> Air Intake System >> Body, Air Cleaner >> Installation

Body, Air Cleaner: Installation

WARNING: This page is about a different variant/trim than selected.
GC0144030Courtesy of CHRYSLER GROUP, LLC
  1. Position the air cleaner housing (3) into the vehicle.
  2. Install the air cleaner housing retaining bolt (2) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Connect the fresh air makeup hose (1) onto the air cleaner housing.
    GC0144029Courtesy of CHRYSLER GROUP, LLC
  4. Position the air inlet hose assembly (5), connect the air inlet hose to the throttle body and the air cleaner housing.
  5. Secure the air inlet hose assembly retaining grommet onto the ball stud (4).
  6. Tighten the clamp (3) at the air cleaner housing to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  7. Tighten the clamp (2) at the throttle body to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  8. Connect the Inlet Air Temperature (IAT) sensor wire harness connector (1).
    GC0144028Courtesy of CHRYSLER GROUP, LLC
  9. Position the engine cover (1) and secure the retaining grommets to the ball studs.
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals