LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (3.6L Engine (Service Information)) >> Air Intake System >> Body, Air Cleaner >> Removal

Body, Air Cleaner: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
    GC0144028Courtesy of CHRYSLER GROUP, LLC
  2. Lift the engine cover retaining grommets off the ball studs and remove the engine cover (1).
    GC0144029Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Inlet Air Temperature (IAT) sensor wire harness connector (1).
  4. Loosen the clamp (2) at the throttle body.
  5. Loosen the clamp (3) at the air cleaner housing.
  6. Lift the air inlet hose assembly retaining grommet off the ball stud (4).
  7. Remove the air inlet hose assembly (5).
    GC0144030Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the fresh air makeup hose (1) from the air cleaner housing.
  9. Remove the air cleaner housing retaining bolt (2).
  10. Remove the air cleaner housing (3).
scientia non olet · About LEMON Manuals