5.7L And 6.4L
WARNING:
Disconnect the negative battery cable before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage the electrical system.
- Disconnect and isolate the negative battery cable.CAUTION:
Do not let the tensioner arm snap back to the freearm position, sever damage may occur to the tensioner.
- Rotate the accessory drive belt tensioner clockwise until it contacts the stop and remove the accessory drive belt, then slowly rotate the tensioner into the freearm position.
- Raise and support the vehicle.
- Remove the belly pan retainers (1) and remove the belly pan.
- Depress the field wire connector tab at the rear of the generator and disconnect the field wire connector.
- Remove the insulator cover from B+ output terminal at the rear of the generator.
- Remove the B+ terminal retaining nut at the rear of the generator and remove the B+ terminal.
- Remove the generator support bracket to engine mount retaining nut (1).
- Remove the generator support bracket retaining bolt (2) and remove the support bracket (3).
- Remove the remaining lower generator retaining bolt (1).
- Lower the vehicle.
- Remove the upper generator retaining bolt (1) and remove the generator (2) from the vehicle.
