Body, Air Cleaner: Installation
WARNING: This page is about a different variant/trim than selected.
- If removed, insert the air inlet tube onto the air cleaner housing and tighten the clamp (3) to the proper specification. Refer to TORQUE SPECIFICATIONS .
- While sliding the air duct onto the throttle body, lower the air cleaner housing into position, then align the air inlet and the locating pin on the bottom of the housing.
- Align the secondary air inlet tube behind the headlamp, there are indexing tabs for orientation.
- Install the air cleaner housing retaining bolt (5) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Connect the make-up air hose (2) to the air inlet tube.
- Connect the Inlet Air Temperature (IAT) sensor wire harness connector (4).
- Position the air inlet tube retaining clamp (1) at the throttle body and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Connect the negative battery cable.