Body, Air Cleaner: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the negative battery cable.
- Loosen the air inlet tube retaining clamp (1) at the throttle body.
- Disconnect the make-up air tube (2).
- Disconnect the Inlet Air Temperature (IAT) sensor wire harness connector (4).
- Remove the air cleaner housing retaining bolt (5).
- While lifting up the air cleaner housing, slide the air duct off the throttle body and remove the air cleaner housing from the vehicle.NOTE:
There is a secondary air inlet duct to the front of the air cleaner housing, behind the headlamp, this must be disengaged for removal.
- If necessary, remove the air inlet tube clamp (3) from the air cleaner housing to remove the air inlet tube.
