LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Emissions Control >> Evaporative Emissions >> Canister, Vapor >> Removal

Canister, Vapor: Removal

NOTE:

The vapor canister is located within the right rear wheelhouse.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the fuel tank filler cap.
  3. Raise and support the vehicle.
  4. Remove the right rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
    GC0144607Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the ESIM wire harness connector (1).
  6. Disconnect the fuel tank vapor line (2) quick-connect fitting from the EVAP canister and position aside.
  7. Disconnect the vapor purge line (3) quick-connect fitting from the EVAP canister and position aside.
    GC0144608Courtesy of CHRYSLER GROUP, LLC
  8. Remove the vapor canister retaining nut (1).
  9. Lower the front of the vapor canister.
  10. Slide the vapor canister forward off of rear mounting brackets.
    GC0081091Courtesy of CHRYSLER GROUP, LLC
  11. Make sure you do not lose the rear mounting bracket rubber mounts.
  12. Remove the vapor canister, ESIM, and fresh air filter from the vehicle as an assembly.
scientia non olet · About LEMON Manuals