LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Emissions Control >> Evaporative Emissions >> Sensor, Fuel Tank Pressure >> Installation

Sensor, Fuel Tank Pressure: Installation

GC0145300Courtesy of CHRYSLER GROUP, LLC
  1. The fuel tank pressure sensor seal (1) can be reused if not damaged.
    GC0152284Courtesy of CHRYSLER GROUP, LLC
  2. Install the fuel tank pressure sensor (1) into the fuel tank vent tube and rotate until it locks into position.
    GC0152112Courtesy of CHRYSLER GROUP, LLC
  3. Connect the fuel filler tube vent line (3) at the filler tube (4) and the fuel tank vent steel line (6).
  4. Connect the fuel pressure electrical connector (1).
  5. Install the rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals