LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (6.4L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Installation

Damper, Vibration: Installation

WARNING: This page is about a different variant/trim than selected.
GC0144946Courtesy of CHRYSLER GROUP, LLC
  1. Using (special tool #10387, Installer, Vibration Damper), install the threaded rod (1) onto the crankshaft (2).
  2. Tighten the threaded rod (4) until it is seated to the face (3) of the crankshaft.
    GC0144947Courtesy of CHRYSLER GROUP, LLC
  3. Position the damper (2) on the crankshaft.
  4. Install the press washer, bearing, washer, and the press nut onto the threaded rod.
  5. Using Damper Installer (1) and a deep well socket, press the damper onto the crankshaft till seated.
    GC0143968Courtesy of CHRYSLER GROUP, LLC
  6. Install a new  vibration damper bolt.
  7. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration damper pulley (3).
  8. Tighten the bolt to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  9. Install the accessory drive belt. Refer to 5.7L/6.4L ELECTRONIC POWER STEERING .
  10. Install the cooling fan. Refer to FAN, COOLING, INSTALLATION, 6.4L DUAL FAN .
    GC0148460Courtesy of CHRYSLER GROUP, LLC
  11. Install the oil cooler hose (4) and clamp (3).
  12. Install the upper radiator hose (2) and clamp (1).
  13. Refill the cooling system. Refer to STANDARD PROCEDURE .
  14. Connect the negative battery cable.
scientia non olet · About LEMON Manuals