Standard Procedure - Fluid Check
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE
.
- Clean the area around the transfer case fill (3) and drain plugs (2).NOTE:
Inspect all the transfer case plug seals and replace as necessary.
- Remove the transfer case fill plug (3).
- Remove the transfer case drain plug (2) and allow the transfer case lubricant to drain into a suitable container.
- When the fluid has stopped draining, install the drain plug (2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Using the fill hole (3), fill the transfer case with 1.0 L +/- 0.05 L (2.11pint +/- 0.11 pint) of fluid. Refer to CAPACITIES AND RECOMMENDED FLUIDS, SPECIFICATIONS .
- Install the fill plug (3) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
