Lamp, Tail Stop Turn: Installation: Lamp: Outer
- Position the tail lamp unit into the tail lamp seat in the end of the quarter panel. Guide the tail lamp alignment pin to seat properly.
- From inside the trunk, install and tighten the two nuts (1) that secure the tail lamp to the inside of the tail lamp seat. Tighten the nuts securely.
- Connect the body wire harness connector (1) to the tail lamp connector receptacle.
- Restore the trunk trim over the inside of the tail lamp seat.
- Clean the surfaces to which the new close out cover must be bonded with a clean, soft cloth soaked with isopropyl (rubbing) alcohol or naptha, then wipe dry.
- Position the new close out cover to the body and over the inboard side of the outer tail lamp. Use hand pressure to secure the integral clips of the cover.
- Peel the release paper off the adhesive patch on the close out cover, then use hand pressure and a resilient roller to wet out the adhesive.
- Connect the battery negative cable.
