Sensor, Park Assist: Removal
- Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
- Remove the rear bumper fascia from the vehicle. Refer to FASCIA, REAR, REMOVAL .
- From the back of the fascia, disconnect the wire harness connector from the park assist sensor connector receptacle.
- Carefully pry the sensor bracket latch features away from the latch tabs of the sensor far enough to disengage the sensor from the bracket.
- Disengage the sensor spacer (O-ring) from around the circumference of the sensor membrane protrusion.