Default Action

WARNING: This page is about a different variant/trim than selected.

The ESM will initiate the following Default Actions only if both position sensors are faulted:
- Shifter background Light Emitting Diodes (LEDs) will be disabled (off).
- Gear Selector indicator LEDs will blink.
- ESM will not send a gear selection signal to the Transmission Control Module (TCM).
- The ESM will send Signal Not Available (SNA) messages out on the Controller Area Network (CAN) C bus and the CAN Dedicated Powertrain (DPT) bus.
- A stored DTC can only be cleared with the scan tool.