Standard Procedure - Filter Service

REMOVAL

1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .

   Courtesy of CHRYSLER GROUP, LLC

2. Remove the transmission oil pan plug (1) and drain the transmission fluid.
   NOTE:

   Inspect the gasket for reuse. If the seal is cut or torn, replace the gasket.

   Courtesy of CHRYSLER GROUP, LLC

3. Remove the 13 oil pan retaining bolts (2).
4. Remove the oil pan (1) and gasket.

   Courtesy of CHRYSLER GROUP, LLC

5. Remove the transmission oil filter (1).

INSTALLATION

Courtesy of CHRYSLER GROUP, LLC

1. Install the NEW  transmission oil filter (1).

   Courtesy of CHRYSLER GROUP, LLC

2. Install the 13 oil pan retaining bolts and tighten to 4 N.m (35 in. lbs.) + 45° in a crisscross pattern, then tighten.

   Courtesy of CHRYSLER GROUP, LLC

3. Verify the transmission oil pan plug (1) is installed.
4. Inspect and adjust the fluid level. Refer to FLUID AND FILTER, STANDARD PROCEDURE .