Rocker Arm, Valve: Removal

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Install Push Rod Retainer (special tool #9070, Retainer, Push Rod) (1).

Fig 1: Rocker Shaft(s) Loosening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown, loosen the rocker shaft assemblies.
CAUTION:
The rocker shaft assemblies are not interchangeable between intake and exhaust. The intake rocker arms are marked with an "I".
Remove the rocker shaft assemblies. Note the location for reassembly.
CAUTION:
The longer pushrods are for the exhaust side, and the shorter pushrods are for intake side.
Remove the push rods. Note the push rod location for reassembly.

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Do not remove the retainers from the rocker shaft assemblies. The assembly tangs (1) at the bottom of the retainers can be damaged, causing the assembly tangs to break off and get into the engine.