Lifter(S), Hydraulic: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
The LH cylinder head hydraulic lifters are shown, the RH cylinder head hydraulic lifters are similar. If the hydraulic lifters are being reused, reassemble them into their original locations.
- Verify that the hydraulic lifters are at least partially full of oil. There should be little or no plunger travel when the hydraulic lifter is depressed.
- Install the hydraulic lifter(s) (1).NOTE:
If the rocker arms are being reused, reassemble them into their original locations.
- Install the rocker arm(s). Refer to ROCKER ARM, VALVE, INSTALLATION .
- Install the camshaft(s). Refer to CAMSHAFT, ENGINE, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.