LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (3.6L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Left >> Removal

Insulator, Engine Mount, Left: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0095584Courtesy of CHRYSLER GROUP, LLC
  3. Remove retainers (1) and the belly pan.
    GC0144794Courtesy of CHRYSLER GROUP, LLC
  4. Remove the ground strap (3) from the left side engine mount stud (2).
    GC0144614Courtesy of CHRYSLER GROUP, LLC
  5. Remove the engine mount isolator heat shield retaining nuts (3) and remove the heat shields (4).
  6. Remove both left and right engine mount isolator to frame retaining bolts (2).
  7. Using a suitable screw jack, raise the engine to gain clearance for engine mount isolator removal.
    GC0144622Courtesy of CHRYSLER GROUP, LLC
  8. Remove the engine mount bolts (1) and the engine mount isolator (2).
  9. If required, remove the engine mount bracket retaining bolts and remove the engine mount bracket.
scientia non olet · About LEMON Manuals