LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (3.6L Engine (Service Information)) >> Engine Mounting >> Insulator, Engine Mount, Rear >> Installation >> AWD

Insulator, Engine Mount, Rear: Installation: AWD

WARNING: This page is about a different variant/trim than selected.
GC0144964Courtesy of CHRYSLER GROUP, LLC
  1. If removed, install the rear engine mount bracket (1) and tighten the four bolts (2) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0144963Courtesy of CHRYSLER GROUP, LLC
  2. Install the rear engine mount isolator (1) with four bolts (2) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0144962Courtesy of CHRYSLER GROUP, LLC
  3. Install the four crossmember (1) bolts (3) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  4. Lower the transmission so the weight is resting on the isolator.
  5. Install the two bolts (2) to the rear engine mount isolator and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals