Pick-Up, Oil Pump: Installation
WARNING: This page is about a different variant/trim than selected.
- Lubricate the new O-ring seal (1) with clean engine oil and install the O-ring onto the oil pump pick-up tube.
- Position the oil pump pick-up tube (1) onto the oil pump and install the retaining bolt (2) finger tight.
- Install the oil pump pick-up tube support bracket retaining bolt (3) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS TORQUE SPECIFICATIONS .
- Tighten the oil pump pick-up tube retaining bolt (2) to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install the oil pan. Refer to PAN, OIL, INSTALLATION .
- If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to OIL .
- Connect the negative battery cable.
- Run the engine until it reaches normal operating temperature and check for leaks.
