Cover(S), Cylinder Head: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect and isolate the negative battery cable.

Courtesy of CHRYSLER GROUP, LLC
Remove the engine covers (1).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the ignition coil wire harness connectors (1).
Position the electrical harness (2) aside.
Remove the ignition coil retaining bolts (3).

Courtesy of CHRYSLER GROUP, LLC
Remove the ignition coils (1).

Fig 1: Cylinder Head Cover Loosening Sequence RH
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown, remove the cylinder head cover retaining bolts.

Courtesy of CHRYSLER GROUP, LLC
Remove the cylinder head cover (1).
Clean the sealing surface of the cylinder head (2).

NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.