Solenoid, Multiple Displacement: Installation
WARNING: This page is about a different variant/trim than selected.
- Verify the Multiple Displacement Solenoid (MDS) bores are free of debris before installing the MDS solenoid into the engine block.
- Install the MDS solenoid(s) (1), ensure the seal is fully seated into the engine block.
- Install the retaining bolt(s) (1) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS
.
- Connect the MDS solenoid(s) (1) wire harness connector.
- Install the foam insulator pad (2) and remove the cover from the engine intake ports (1).
- Install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION .
