Linkage, Wiper Arm: Removal

Courtesy of CHRYSLER GROUP, LLC

NOTE:

The wiper motor can be removed from the wiper linkage module and is serviced independently from the remainder of the wiper linkage module for this vehicle. Refer to MOTOR, WIPER, REMOVAL .

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove both wiper arms from the wiper pivots. Refer to ARM, WIPER, REMOVAL .
Remove the cowl plenum cover/grille panel from over the wiper module (2). Refer to COVER, COWL PANEL, REMOVAL .
Remove the foam mucket (3) from the left wiper pivot cup.
Disconnect the wire harness connector (6) from the connector receptacle for the wiper motor.
Remove the two screws (1) that secure the module bracket to the cowl.
Pull the wiper linkage module toward the outboard side of the vehicle far enough to disengage the knob-like rubber isolator (5) from the slotted bracket (4) on the front shock tower brace.
Remove the wiper linkage module from the cowl as a unit.