LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System (Service Information) >> Reservoir, Windshield Washer >> Removal

Reservoir, Windshield Washer: Removal

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
    GC0144791Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the headlamp and dash wire harness (1) connector for the washer pump (5) from the washer pump motor (7) connector receptacle.
  4. Disconnect the headlamp and dash wire harness connector for the washer fluid level switch (6) from the switch (3) connector receptacle.
  5. Disconnect the washer hose (2) from the barbed outlet nipple of the washer pump and allow the washer fluid to drain into a clean container for reuse.
    GC0144793Courtesy of CHRYSLER GROUP, LLC
  6. Remove the two screws (2) that secure the washer reservoir (1) to the outboard side of the right frame rail (3).
  7. Lower the washer reservoir from the vehicle, rotating it as necessary for clearance.
scientia non olet · About LEMON Manuals