Seat Bottom Vented Motor
WARNING:
Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE:
On all models, the front passenger seat contains an Occupant Detection Sensor (ODS) to provide information to the Occupant Restraint Controller (ORC).
- Install the vented seat motor to the seat bottom frame using the new plastic tabs (1).
- Position the cushion assembly onto the seat adjuster.
- Align the seat cushion ventilation plenum (3) with the tabs (1) on the seat cushion blower (2) and snap into place, if equipped.
- Connect the wiring harness to the vented seat connector (1).
- Install the seat back cushion and cover. Refer to COVER, SEAT CUSHION, REAR, INSTALLATION .
