Instrument Panel

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Courtesy of CHRYSLER GROUP, LLC

Position the back of the deck lid release switch (3) through the hole in the retainer yoke (4).
Position the switch and retainer to the back of the steering column opening cover (1).
Install and tighten the two screws (2) that secure the switch and retainer to the back of the cover. Tighten the screws securely.
Reinstall the steering column opening cover onto the instrument panel. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
Reconnect the battery negative cable.