Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, create a Vehicle Scan Report and attach it to the repair order.
2. With the scan tool, read PCM DTCs.
  Are there any PCM Charging or Battery DTCs present?
  
  Yes
  - Repair the PCM DTC(s). Refer to DTC INDEX .
  No
  - Go To 2
CHECK THE PASSENGER DOOR MODULE
1. Start the engine and run for two minutes.
2. With the scan tool, read the PDM DTCs.
  Is the DTC active?
  
  Yes
  - Replace the Passenger Door Module in accordance with Service Information. Refer to MODULE, DOOR (DDM/PDM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension and repair as necessary. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .