Diagnostic Test

CHECK IF TCM IS CORRECT 

1. Flash and reprogram the TCM with the correct software in accordance to the Service Information.
2. Perform NAG1 TRANSMISSION VERIFICATION TEST. Refer to NAG1 TRANSMISSION VERIFICATION TEST  .

   Did the DTC reset after the Verification Test?

   Yes 

   • Using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the TCM per the Service Information.
   • Perform NAG1 TRANSMISSION VERIFICATION TEST. Refer to NAG1 TRANSMISSION VERIFICATION TEST  .

   No 

   • Test Complete.