LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Audio/Video/Entertainment/Connectivity (Service Information) >> Speaker >> Installation >> Spacer - Shelf Panel Subwoofer

Spacer - Shelf Panel Subwoofer

GC0170698Courtesy of CHRYSLER GROUP, LLC
NOTE:

This spacer is used only for vehicles equipped with a 25.4 centimeter (10 inch) diameter subwoofer mounted on the package shelf panel. The spacer is mounted between the package shelf panel and the subwoofer.

  1. Position the spacer (2) onto the shelf panel support.
  2. Install and tighten the four screws (1) that secure the spacer to the shelf panel. Tighten the screws securely.
  3. Install the subwoofer onto the spacer on the package shelf panel. Refer to SPEAKER, INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals