LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> Dismounting/Mounting Procedures >> Tire Pressure Sensor >> Removal (Non-SRT8 Models)

Removal (Non-SRT8 Models)

  1. Remove tire and wheel assembly from vehicle.
  2. Dismount tire from wheel following tire changer manufacturer's instructions while paying special attention to the following to avoid damaging the pressure sensor:
    • When breaking the tire bead loose from the wheel rim, avoid using the Bead Breaker in the area of the sensor. That includes both front and rear beads of the tire. See Figure.
    • When preparing to dismount the tire from the wheel, carefully insert the mounting/dismounting tool 280° from the valve stem +/- 10°, then proceed to dismount the tire from the wheel. Use this process on both the upper and lower tire beads.
  3. Remove the sensor to valve stem retainer screw (3) and remove the sensor (1) from the valve stem (2). See Fig 2.
  4. Remove the valve stem (2) from the wheel (4). See Fig 2.
Fig 1: Identifying Tire Pressure Sensor Components (Non-SRT8)
G00494513Courtesy of CHRYSLER GROUP, LLC
Fig 2: Removing & Installing Tire Pressure Sensor (Non-SRT8)
G00494512Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals