LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Suspension >> Front Suspension & Wheel Alignment >> Front >> Knuckle, Steering, RWD >> Removal

Knuckle, Steering, RWD: Removal

NOTE:

Removal process is the same for both sides of the vehicle.

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
  3. Remove the front wheel speed sensor. Refer to SENSOR, WHEEL SPEED, FRONT, REMOVAL .
    GC0170355Courtesy of CHRYSLER GROUP, LLC
  4. Remove the front brake hose support bracket bolt (1) and position bracket away from knuckle (2).
  5. Remove front brake rotor. Refer to ROTOR, BRAKE, REMOVAL .
  6. Remove outer tie rod end from knuckle. Refer to TIE ROD, STEERING, REMOVAL .
  7. Remove the upper ball joint from the knuckle. Refer to ARM, UPPER CONTROL, REMOVAL .
  8. Remove the tension strut from the knuckle. Refer to STRUT, TENSION, REMOVAL .
  9. Remove the lower ball joint from the knuckle. Refer to BALL JOINT, SUSPENSION, LOWER, REMOVAL .
  10. Remove knuckle (2) from vehicle.
scientia non olet · About LEMON Manuals