LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Heating & Air Conditioning (Service Information) >> Controls >> Actuator, Blend Door >> Removal >> Right Side

Right Side

GC0170245Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the push fasteners, disconnect the wire harness connector and remove the instrument panel closeout (3).
  3. Remove the glove box and the glove box trim panel from the instrument panel. Refer to GLOVE BOX, INSTRUMENT PANEL, REMOVAL .
    GC0170290Courtesy of CHRYSLER GROUP, LLC
  4. Remove the two screws (1) that secure the blend door actuator (3) to the right side of the HVAC air distribution housing (4).
  5. Remove the blend door actuator from the air distribution housing. Disconnect the HVAC wire harness connector (2) and remove the actuator from the vehicle.
scientia non olet · About LEMON Manuals