LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2018 >> Charger Pursuit, 5.7L Eng VIN T, 4WD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Heating & Air Conditioning (Service Information) >> Controls >> Actuator, Mode Door >> Installation

Actuator, Mode Door: Installation

GC0144757Courtesy of CHRYSLER GROUP, LLC
  1. Position the mode door actuator (1) to the mode door cam (3).
  2. Install the mode door actuator onto the bracket (2). If necessary, rotate the actuator slightly to align the splines on the actuator output shaft (4) with those on the mode door cam (3).
    GC0170116Courtesy of CHRYSLER GROUP, LLC
  3. Install the two screws (4) that secure the mode door actuator (2) to the bracket (3) and securely tighten the screws.
  4. Connect the HVAC wire harness connector (1) to the mode door actuator.
  5. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  6. Install the left side instrument panel closeout.
  7. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  8. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals